(OFF) Посоветуйте мультитрекер |
Здравствуйте, гость ( Вход | Регистрация )
(OFF) Посоветуйте мультитрекер |
| Иван Булочкин (гость) |
4.12.2002, 19:06
Сообщение
#1
|
|
|
Чувки, давно и безутешно ищу эту схему.. помогите плиз
|
|
|
|
|
|
![]() |
9.1.2006, 5:18
Сообщение
#2
|
|
![]() Сообщений: 278 Регистрация: 27.8.2003 Из: Мытищи |
Correct for Start Sync in Recordings
If this box is checked, Adobe® AuditionTM looks at the exact true time that the record device started and compares that with the time the master playback device started. If different, the recorded block’s position is adjusted so the recording starts in perfect sync with the playback. This option only works with new record tracks, not with recording on top of existing waveforms, or punch-ins.
If you have this option enabled, and you do a loopback test (by connecting the audio Out to the audio In and recording some “ticks”) and each recording is still a fixed amount out of sync, then you can adjust for this by entering this amount (in milliseconds) in the Latency field of Options > Device Properties for the recording device being used. To compute milliseconds, look at the difference in samples, multiply by 1000 and then divide by the sample rate. For example, if the recording consistently appears 27 samples ahead of the playback, the latency would be 27 * 1000 / 44100 or 0.61 ms. (The reason for the milliseconds format and not samples is because at various sample rates this latency will be different in terms of samples, but will be the same in terms of milliseconds.)
On sound cards that support sample accurate devices (i.e., synchronized device starting, and all devices keyed off of the same clock) you don’t need to check this box. This option allows for some measure of near sample-accurate synchronization across different sound cards, or when using with a single sound card that doesn’t use the same clock for playback and recording (such as the Sound Blaster Live! card).
|
|
|
|
![]() ![]() |
<% %> <% %> |
Текстовая версия | Сейчас: 9.5.2026, 14:40 |