Engl E430/530 vs Mesa V-Twin vs Tubeman vs BadCat X-treme Опции

[Иван Булочкин (гость)]

Чувки, давно и безутешно ищу эту схему.. помогите плиз

[ПП.]

По Поводу BadCat Внизу отрывок из описания примочки BadCat 2-Tone с сайта harmony-central. В кратце - человек утверждает что в педали используются много некачетсвенных деталей (в частности фильтры и резисторы). После их замены прибор зазвучал. А до этого прямо из коробки никак. Так ли это? Кроме того если ее пишут через ПОД, то ПОД у меня есть и я не слишком удовлетворен его звуком. Даже на концертах. 2F61: Позвоню, Спасибо. $400 может и есть - только хотелось знать что предлагается :) 2Anton Tsygankov 2Евгений Спасибо за инфо :) "I build my own amps and am familiar with component quality and such so I opened the pedal up to see what the matter was. I found that there are inferior quality parts used in the is pedal compared to the matchless pedal. It still uses the good-quality caps of the Matchless pedals (they are even labeled 'Matchless' in mine), but the resistors are not carbon composition this time, but metal film. Also the filter caps are cheap over-seas made. The other problem to me was that it was over-filtered. I understand that one of the design points of this pedal was implementing some less noisy parts/layout. I think this is the reason for the over-filtering and the metal-film resitors. So I replaced the resitors with metal film, the cheap caps with USA made and lowered the filtering to where it should be (about 22uf each). Lowering the filters reduced the muddiness and made it more clear and just more musical and less choked off sounding. After all these changes, it sounds very,very good. They way it should have sounded right from Badcat. The built quality and parts quality are not as high as on the matchless pedals. Those things had insulation on every single lead! The 2-tone needs this insulation. The other problem was that a couple of leads were touching when that should not have been. If you open it up, you'll see how close these leads are to each other! Also the tube sockets on the Matchless units were shock-mounted and they are just bolted on in the Badcat. Overall, not the quality I was expecting. I'm rating the sound quality based on how it sounded stock. After the changes I made it really does sound great (I tried to detail them here in case anyone wants to improve their unit). It's a good design, but is ruined with parts that creat a poor sound quality. On the plus side, even though the resistors contribute to a harsh sound, they are rated high and should not burn out."